Black BLK-HDPTZ12 Manual do Utilizador descarregar pdf (Página 14)

SECTION 2: INSTALLATION

SW303 switch

The SW303 block switch contains 5 on/o switches. These switches are used as follows:

— Switch 1 (video mode):

» ON: CVBS is NTSC

» OFF: CVBS is PAL

— Switch 2 (RS-485 protocol)

» ON: Pelco P / D

» OFF: Pelco P/ Others

— Switches 3 and 4 are used together to set the RS-485 baud rate as shown in the table below.

Switch 3 Switch 4 Baud rate

O O 2400

O On 4800

On O 9600

On On 38400

— Switch 5 sets the state of the RS-485 network termination:

» ON: RS-485 terminated

» OFF: RS-485 not terminated

4. Reattach the dome cover to the camera module with the three screws removed earlier.

2.4 Attach the camera module to the mounting bracket

CAUTION



When handling the camera with the dome cover attached, be extremely careful not to scratch or damage the dome cover.

1. Lift the camera module to mounting bracket, then route the camera drop cable into the bracket and out through the cable

access opening.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 51 52

Sem comentários

Black BLK-HDPTZ12 Manual do Utilizador Página 14